![]() ![]() I am absolutely sure the specific light is no on at that moment. Off course, it has something to do with a new day and the time-window or before 05:00 but that shouldn’t be true since the rule started with trigger: hal-verlichting is turned on. I have no clue why this rule becomes active at exactly 0:00 ? Info : rule hal-verlichting-dimmen-in-de-nacht: dimmed Hal verlichting dimmer to 25% Since I have created the extra rules for dimming one of them becomes active at exact 0:00 every night: model able to make predictions about the motion when given a set of background parameters, age, joint health, breed, and strategies used to retrieve the toy. Again, 10 minutes later the light is turned off. The light is turned on again and gets dimmed to 25%. Sometime later on 23:05 a other person enters the hallway. ![]() Right after that the light is dimmed to 50% and 10 minutes later the light is turned off. The goal for these extra rules: adjust the dimlevel according to the time at the moment the light is turned on.Įxample: on 22:45 someone enters the hallway and the light is automatically turned on. WHEN trigger: hal-verlichting is turned on and it is after 05:00 and before 23:00 THEN dim hal-verlichting-dimmer to 50% Constant speed doesnt necessarily mean constant velocity, but constant velocity. Other units used are kilometers per hour (kph), miles per hour (mph), feet per second (fps). The SI unit used for speed and velocity is meter per second (m/s). WHEN trigger: hal-verlichting is turned on and it is after 23:00 or before 05:00 THEN dim hal-verlichting-dimmer to 25% Distance is a scalar quantity that refers to 'how much ground an object has covered' during its motion. When there is movement and the lux is to low, the light is turned on for 10 minutes. WHEN xiaomi-pir-overloop-dummy reports present and lux of xiaomi-pir-overloop <= 15 and hal-verlichting is off THEN turn on hal-verlichting for 10 minutes I want to turn on the light when there is movement detected and the lux is below a certain level. That same light is controlled with protocol dimmer1 to adjust the dimlevel I have on light that is controlled with protocol switch1 to turn it on and off I have 2 PIR sensors, one in the hallway downstairs and one in the hallway upstairs. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |